Pan/Tilt Offsets

Pan and tilt offsets add a fixed correction to the computed output values for a fixture.

In the Fixture Settings tab of the Tracking Settings panel (right column), use the Pan Offset and Tilt Offset sliders.

When to use

• Fixture has shifted slightly since calibration (small drift, no full recalibration needed).
• You want to offset the beam slightly from the calibrated position.

Controls

Pan Offset and Tilt Offset each range from −100% to +100%, where ±100% represents the full extent of the offset range. Offsets are applied after the calibration mesh transform.

Both can be reset to 0 using their reset button.

For larger corrections, recalibrate the mesh rather than relying on large offset values.